
Guide
Setting up and caring for a nitrided table
A nitrided top resists spatter and wear, but setup and a few habits decide how long it stays flat and clean.
Set it level first
Put the table on solid, flat concrete. Level it across both diagonals with a precision level, using adjustable legs or steel shims under fixed legs. A table that rocks or sits out of level will fight every square and stop you set on it.
Ground it properly
Clamp your welder’s ground to the table or use a ground connector seated in a system hole. Keep the contact clean and bright, and keep the ground close to the work so current doesn’t travel through bolts and clamps.
Keep spatter off
- Use an anti-spatter spray on the top before heavy MIG work.
- Knock spatter off while it’s fresh, with a scraper or stiff brush.
- Clean the holes with a hole brush so bolts seat fully and lock square.
- Take burrs down with an oilstone, never a grinder.
Don’t cut or strike on the top
Don’t grind, torch-cut or strike an arc directly on the surface. Use a sacrificial plate or a scrap piece under the work for cutting.
Stop rust before it starts
Nitriding improves corrosion resistance, but humid shops still need a thin coat of light machine oil, especially over weekends and in winter. Wipe the top down before precision work.
Look after the fixturing
Clean bolts and clamps, check locking bolts for wear and keep them oiled. Store squares and stops flat so they stay true.
Our shop and maintenance parts include hole brushes, oilstones and oil cans.

Get a written quote
Pick a table and your ZIP. Price, freight, spec sheet and terms come back in one business day.